I have a Circuit Breaker for the Stove Top circuit that keeps tripping especially in warm weather. I need a evaluation of possible faults/shorts and then a replacement Breaker. Not an emergency, just annoying!

Peter W

(1) remove and blank off smoke detecitor above stair well - (awkward location) (2) install new smoke detector in mor convenient loaction (3) replace fault rheostat for chandilier (4) evaluate and possibly repair/replace attic fan and/or temperature sensor for attic fan that is not running

Paul O

We are experiencing flickering lights, in our overhead and lights in wall sockets. Need your electrical expertise to diagnose and repair the problem.

Jeff C

We need to add some electrical outlets in our kitchen and also upgrade our circuit breaker box in the basement becuase its full. Thanks!

Chris P

Recently purchased an older home. Looking to upgrade some power outlets, lighting fixtures, outdoor lighting, and garage. Also would like a bid on replacing the breaker panel.

Susan B

Want to add more refrigeration to my commercial kitchen. May need to increase the size of my electric panel.

Bobby W

I'd like a ceiling fan installed in my bathroom. SIngle story home, existing light junction that can be repurposed for a fan if possible. Friday morning is open for me until 12:00 pm if you have availability.

Barbara B

We have 2 sets of flouresent lights in our Kitchen which has a vaulted ceiling. I have replaced the bulbs but the lights only come on dim or not at all. We would like to have them repaired.

Brian J

Old house old panel. Need new panel and about 8 new outlets. Panel stays in same location. New wire must be brought from pole because old wire crosses over built-on den.Rep from city elec. has been here and drawn up 'spot location' map. I must get bids and know how much this is going to cost.

M

I need to have a dedicated line for my microwave. it currently is on the same circuit as the master bedroom and causes several outages. The microwave is about 10 linear feet from the breaker box and there should be enough space on the breaker box to add a new breaker for the microwave.

Juan C